© Copyright
MINOS DIS TICARET LIMITED SIRKETI., 2020. All rights reserved. Reprinting, even of sections, only possible with the approval of
MINOS DIS TICARET LIMITED SIRKETI.
Document No: T-MDR.2020_I.O.M./ Date: 09.01.2020
immediately, idle the engine speed and disengage the PTO. Wait for stopping
of all rotating parts, then raise the machine and proceed to removing the
object, after stopped the tractor, set the parking brake, stopped engine and
removed the ignition key. Repair any damages immediately, and make sure
rotor and blades are in good condition before restarting operation;
● Always disengage the tractor PTO when the PTO Shaft exceed an angle of 10
degrees up or down between end yokes while operating. An excessive angle
with PTO Shaft rotating can break the PTO Shaft and cause flying projectiles.
● Avoid friction clutch overheating caused by too long or too frequent slipping
of the clutch (friction discs clutch or cam-type clutch), since this can damage
the friction plates and/or clutch parts. In case of functioning problem, do not
open the clutch but contact the Manufacturer or a service center.
● Some of typical problems that may occur when operating the machine are
described into
section 8
, together with their possible solutions.
ATTENTION! All adjustment operations must be performed with the tractor
engine off, the PTO disengaged, the machine lowered to the ground or on
security stands, the parking brake set and the ignition key off.
Secure blocking prevents equipment from dropping due to hydraulic leak
down, hydraulic system failures, or mechanical component failures!
4.3- Adjustments & Precautions
30
● If you need to get off the tractor, lift the machine just out of the ground,
reduce engine speed and disengage PTO, set the parking brake, stop engine
and remove the ignition key!
33