![background image](http://html1.mh-extra.com/html/minn-kota/terrova-copilot/terrova-copilot_owners-manual_1802760009.webp)
minnkotamotors.com | 9
©2019 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
k. Take the new CoPilot Cover (Item #1) and place it
over the CoPilot Receiver that was just installed.
Attach the CoPilot Cover to the Right Sideplate with
the three 8-18 X 1/2 Screws (Item #3) using a #2
Phillips Screwdriver.
l. Remove the Dust Cap from the Connection Port
located towards the back end of the exposed side of
the motor on the right side of the Mount.
m. Take the Power Connection that comes off of the
CoPilot Receiver, which is attached to the Right
Sideplate and plug it into the Connection Port.
CoPilot Cover
CoPilot Cover
CoPilot Receiver
CoPilot Receiver
Screws
Screws
Power
Power
Connection
Connection
Antenna
Antenna
NOTICE:
The old CoPilot Cover that was removed
at the beginning of the installation will no longer
fit on the Right Sideplate. This helps to make sure
that the new CoPilot Cover is installed in case of an
accidental mix-up.
NOTICE:
Do not apply lubricant or any type
of grease to trolling motor connectors. Make
sure that the flat sides of the Power Connection
and Connection Port align so the plugs connect
together correctly.
ITEM(S) NEEDED
#3 x 3
#1 x 1
n. Be sure that the Power Connection sits comfortably
between the Mount and the Right Sideplate and
cannot be pinched.
o. Reseat the Right Sideplate.
Right Sideplate
Right Sideplate
Mount
Mount
Dust Cap
Dust Cap
Connection Port
Connection Port
Power
Power
Connection
Connection
Connection Port
Connection Port
Power Connection
Power Connection
6
7
8
7l
7m