F3 COMPACT Service Manual
_______________________________________________________________________________________________________________________
20
•
Ease the two halves of the detector together. Align the detector body right side with the
locating pins either side of the shaft hinge.
•
Check the latch hinge and spring latch hinge are in place and connected.
•
Once the two sides of the detector are together check the handle, shafts and armrest
slide are correctly fitted. Carefully hold the detector together whilst turning the detector
over onto its right side with the hinge cover facing up.
•
Remove the hinge cover to check the coil cable is not trapped within the shaft hinge.
•
Check the latch hinge and spring latch hinge are still connected as shown in Figure 19.
•
Refit the hinge cover.
•
Insert the four screws (two 20mm and two 35mm) as indicated in Figure 22 but do not
fully tighten at this point.
•
With the detector loosely held together check the handle slides up and down correctly.
Check the armrest slide also moves freely along the rod detector slide.
•
Check the battery lid moves in and out and ensure the battery lid is closed.
•
Starting with the two long (35mm) screws fit the four remaining screws into the right side
of the detector as indicated by the arrows in Figure 23.
•
Tighten all eight screws.
Figure 22: Fitting Four Screws
