Accutorr Plus™ Operating Instructions
3 - 27
Operation
Temperature Measurement (Optional)
5.
RECTAL TEMPERATURES - Use a RED rectal probe assembly. Install a probe cover as
instructed for oral temperatures, and insert the probe into the patient’s rectum. To insure
proper tissue contact, angle the probes lightly after insertion. Insertion depth is
recommended at 1/2" to 3/4" for adults and 1/4" to 1/2" for children. A lubricant
may be used if desired. The measurement will proceed similarly to the oral
measurement, and the final reading will be displayed when the display stops flashing.
FIGURE 3-9
Probe Placement for Axillary Temperatures
6.
AXILLARY TEMPERATURES - Using the RED rectal probe, install a new probe cover in the
normal manner. Have the patient raise his/her arm. Place the probe tip in the axilla,
pressing gently to assure good contact. Have the patient lower his/her arm, holding the
probe in position almost parallel to the arm. The measurement will proceed similarly to
the oral measurement, and the final reading will be displayed when the display stops
flashing.
FIGURE 3-10
Probe Placement for Axillary Temperatures
NOTE:
It is important that the tip of the probe does not come into
contact with a heat source(i.e., hands or finger) prior to
taking a temperature. If this should happen, allow at least 5
seconds for the tip to cool before proceeding with the
reading.
NOTE:
The thermometer will turn itself off about 3 minutes after
turning it on, or when the probe is returned to the probe
chamber (50). Always store in the chamber for the
protection of the probe and to reset the temperature
module.
NOTE:
The thermometer will not take a reading if the patient
temperature is less than 6°F (3.3°C) above the ambient
temperature.
