Minarik RG300 Series, User Manual

Page: 3 / 64

m
Safety Warnings
•
This symbol
m
denotes an important safety tip or warning.
Please read these sections carefully prior to performing any of
the instructions contained in that section.
•
Have a qualified electrical maintenance technician install,
adjust and service this equipment. Follow the National
Electrical Code and all other applicable electrical and safety
codes, including the provisions of the Occupational Safety
and Health Act (OSHA), when installing equipment.
•
Reduce the chance of an electrical fire, shock, or explosion by
proper grounding, over-current protection, thermal protection,
and enclosure. Follow sound maintenance procedures.
•
It is possible for a drive to run at full speed as a result of a
component failure. Please ensure that a master switch has
been placed in the AC line to stop the drive in an emergency.
•
This drive is isolated from earth ground. Circuit potentials
are at 115 VAC or 230 VAC above earth ground. Avoid direct
contact with the printed circuit board or with circuit elements
to prevent the risk of serious injury or fatality. Use a non-
metallic screwdriver for adjusting the calibration trimpots.