Armature filters
If the end-user is not using a CE-approved motor, a CExxRG
filter must be used on the armature. “XX” refers to the rated
current of the filter.
The CE20RG is a Real-Pole Balanced-Pi 3-pole filter. If the
exact filter is not available, the specifications are as follows:
L & L1 = 2 * (0.8) milliHenries.
C & C1 = 2 * (0.1) microFarads @ 400W VDC.
Rin = 0.1 ohm; Rout = 1.2 ohm.
Table 4. Minarik® Filters
Nameplate Current of
Minarik® Filter
Motor Wired to the Drive
Part Number
0 to 4 amps
CE04RG
4.1 to 13 amps
CE20RG
The filters in Table 4 must be wired to the DC output of the
drive, as close to the drive as possible.
48
CE Compliance
Summary of Contents for RG300 Series
