Minarik RG300 Series, User Manual

Page: 18 / 64

Mounting cased drives (continued)
1. Install the mounting screws.
2. For access to the terminal strip, turn the slotted screw on
the front cover counterclockwise until it is free from the
case. The right side of the cover is hinged to the case. Lift
or pull the slotted screw to open the case.
3. Carefully remove the conduit knockouts by tapping them
into the case and twisting them off with pliers.
4. Install conduit hardware through the 0.88 inch (22 mm)
conduit holes. Connect external wiring to the terminal
block.
5. Grasp the slotted screw and tilt the front cover back into
place. Avoid pinching any wires between the front cover
and the case.
6. Turn the slotted screw clockwise until tight to secure the
front cover.
7. Set the POWER switch OFF position before applying the
AC line voltage.
10
Installation