2-11
1
2
Basic Operation
s
4
5
6
Setting a Media
3
Remove the roll holders.
• The roll holders are on both for the right and left of the roll holder. Remove both with the procedures
below:
(1)
While lifting the lever of the roll holder stopper, rotate it
to the position indicated in the figure.
(2)
Get off of the lever once, and rotate it to the direction
indicated in the figure to loosen it.
(3)
Repeat the Step (1) and (2) to release the lock of the roll holder.
(4)
After rotating the handle of the roll holder
counterclockwise, take out the roll holder.
4
Set a media on the roll shaft.
(1)
Put the roll shaft through the paper core of the media.
(2)
Adjust the media so that it comes to the center of the
roll shaft.
(3)
Push right and left roll holders into the paper core, and
rotate the handle of the roll holder clockwise.
• Firmly insert it so that the paper core does not run idle.
• When setting the paper core, set it so that it
may come to the center of the roll shaft by
referring to the media setting position
nameplate attached with the main body.
Roll holder
stopper
Loosen it by
rotating
anticlockwise.
Roll holder
Roll holder
stopper
Summary of Contents for UJV500-160
