4-34
12
Press the
key several times to return to LOCAL.
Setting the P/C SCALE ADJUST
Adjust the scale to apply cutting to the expansion or contraction of the print caused by the media-feeding
correction.
1
Set a PVC medium (
P.2-15), and attach the eccentric cutter for cutting
(
P.2-10).
2
Press the
key in LOCAL to select the cutting
mode.
3
Press the
key.
4
Press the
key.
5
Press
to select one from the tool conditions (CUT1 to CUT3, PEN, and
HALF) and press the
key.
6
Press
to select [P/C ADJUST] .
• Even if you adjust with the P/C origin offset, misalignment may occur when you print & cut data actually
in some cases. In such a case, you can adjust again by the procedures below:
(1)
Press the
key to select the cutting mode.
(2)
Press the
key to switch to the remote status.
(3)
Press the
key.
(4)
Adjust by pressing
.
• Change the direction of X/Y with
, and enter the
offset value with
.
(5)
Press the
key to save the adjusting value.
• When you save the adjusting value, the value registered with the P/C origin offset is updated.
• If you do not wish to save the adjusting value, press the
key or the
key.
• When a medium used or the feeding correction value is changed, readjust it as needed. (When starting
to print the pattern, the former setting is initialized.)
• This setting fits the cutting position to the printing position. Please note that the value adjusted here is
also applied to cut only or to draw with a pen by PEN tool.
• If you do not want to apply this setting for cutting only, perform the followings.
→
Select "Clear" on Step 9.
→
Cut with a tool condition without the P/C scale correction.
P / C OR I G I N OF S .
X = 0
Y = 0
< LOCA L .
C
>
[ # 0 1 ]
CUT 1 ( 3 0 /
6 0 /
0 . 3 0 )
FUNCT I ON
C
SE TUP
< ENT >
SE TUP
SE L ECT
: CUT 1
[ CUT 1 ]
P / C AD J US T
< e n t >
Summary of Contents for CJV30-100BS
