MIMAKI CJV30-100BS, Operation Manual

Page: 23 / 296

1-7
Names of Parts and Functions
1
Before U
se
Heater
Pre-heater/Print heater/Post-heater are equipped on the platen.
The Pre-heater is used for pre-heating of the media prior to printing to prevent rapid changes in temperature.
The Print-heater improves the image quality in printing. The Post-heater dries ink after printing.
Media Sensor
The media sensor detects the presence of the media and the media
length.
This machine has a media sensor on the platen (in the rear).
• While the heater is on, the platen is very hot. When the front cover (Optional) is to be opened or media
is to be replaced, lower the heater temperatures and wait until the platen temperature drops; otherwise,
you can get burned.
• When the media is to be replaced with a thin one, lower the heater temperatures and wait until the
platen temperature drops adequately. Setting a thin sheet of media while the platen is hot may cause
the media to stick to the platen or cause wrinkling or curling of the media.
• Set the media so that the media sensor located in the rear
of the platen is covered with the media without fail. The
media cannot be detected unless it is placed over the
sensor.
Post-heater Print heater Pre-heater
Media sensor