MIMAKI CJV30-100BS, Operation Manual

Page: 12 / 296

xi
Precautions for Use
Caution
About Power Supply Prohibition of Use in a Poorly Ventilated Room
• Do not turn off the main power switch on the right
side of this machine.
• If you get ink in your eyes, immediately wash
your eyes with a lot of clean water for at least 15
minutes. In doing so, also wash eyes to rinse ink
away completely. Then, consult a doctor as soon
as possible.
• If anyone drinks ink by mistake, keep him or her
quiet and see a doctor immediately Do not allow
him or her to swallow the vomit. After that,
contact the Poison Control Center.
• If you inhale a lot of vapor and feel bad,
immediately move to a location of fresh air and
then keep yourself warm and quiet. Then, consult
a doctor as soon as possible.
About the Heaters
• Do not spill liquid on the platen as this may cause
failure of the heater or firing.
• Do not touch platen heaters with bare hand while
it is hot; otherwise, you can get burned.
• When the machine is to be moved, wait until the
heater temperature drops adequately. As a
criterion, wait at least 30 minutes after you turn
off the power to the heater. Moving the machine
must be limited to on the same floor where there
is no steps. When the machine is to be moved to
any place other than on the same step-free floor,
contact your distributor or a sales office of
MIMAKI.
• The ink contains organic solvent. If ink has stuck
to your skin or clothes, immediately wash it off
with detergent and water.
How to Handle Ink Caution about the Moving Parts
• When cleaning the ink-station or the heads, make
sure to wear the attached gloves. Further, when
the solvent ink is used, it is necessary to wear the
attached goggles.
• Do not touch the rolling grid roller; otherwise, you
may hurt your fingers or tear off your finger nails.
• Keep your head and hands away from any
moving parts during a printing or cutting
operation; otherwise, you may get your hair
caught in the machine or get injured.
• Wear proper clothes. (Do not wear loose-fit
clothes or accessories.) Also, bind a long hair.
• Each unit is automatically switched to in concert
with the movement of printing or cutting. Do not
make your face or hands near above the platen.
Also, do not place a small object or a tool.
About Media
• Straighten the sheet of media, if significantly
curled, before using it for printing. Heavily curled
sheet affects the printing or cutting result.
About the Cutter
• Do not touch the cutter blade, which is very
sharp.
• Do not shake or swing the cutter holder;
otherwise, the blade may come off.