MIMAKI CJV30-100, Operating Manual

Page: 226 / 274

7-8
Message Cause Solution
As the connection unit is not connected to the
print head, regular operations cannot be
executed. Start the origin setting in the print mode, and
switch the connection unit, or execure the
appropriate regular operations manually.
The waste ink tank is nearly full.
Replace the waste ink tank, and then execute
[MAINTENANCE]-[Ink Tank Replace].
(
P.6-39)
The cleaning liquid cartridge is empty.
Replace the cleaning solution cartridge with a
new one.
The cleaning liquid cartridge has not been
installed.
Install the cleaning solution cartridge.
There is trouble with the cleaning liquid
cartridge.
Install the cleaning solution cartridge.
Cleaning solution has not been supplied.
Supply the cleaning solution.
Execute [MAINTENANCE]-
[HD.MAINTENANCE]-[FILL UP INK].
(
P.6-18)
** OFFSCALE **
The cutting data exceeds the effective cutting
area.
Or the machine has stopped after cutting the
medium up to its end normally. Use a larger medium, decrease the amount
of data, or execute the divided cutting
function.
** END COPY **
The plotter has terminated copying after
completion of one sheet copying, since the data
received contains the origin updating command.
The plural sheets cutting function is
disabled.
To perform plural sheets cutting, change
the setting back to enable the function on
the host computer.
** DIVISION ** 5s
The machine has finished the cutting
corresponding to a division of the data that
exceeds the medium width, using the division
cut function, and is now waiting for the receipt of
the next data.
If the machine does not receive any data
from the host computer within ten seconds,
it will recognize that the data has ended.
Then, the machine will perform the frame
cutting and mark cutting and enter LOCAL.
** END DIVISION **
This message appears in any of the following
cases:
The medium width is 1 cm or less.
The sample cutting data exceeds the medium
width.
The two-point axis alignment is set to ON.
Register marks have already been detected. Division cut is disabled.
COPY SKIP
A register mark cannot be detected during
continuous copying. (One pattern is skipped.)
There is no problem if the marks are successfully
detected after skipping one pattern.
If marks cannot be detected continuously by five
patterns or more, [ERROR 36-C MARK
DETECT] (
P.7-12) is displayed.
MEDIA SKEW <ENT> Sheet misalignment exceeds the setting length
of skew check (
P.4-14).
Set the sheet again and press the
key.
PAUSE REM/END
The plotter is holding the register mark detecting
operation, since the
key has been
pressed during the detection process.
Press the key to resume the mark
detection.
Or press the
key to end the operation.
< L O C A L . 1 > ! R T N [ # 0 1 ]
* R E MO T E . 1 * ! R T N [ # 0 1 ]
< L O C A L . 1 > ! T N K [ # 0 1 ]
* R E MO T E . 1 * ! T N K [ # 0 1 ]
< L O C A L . 1 > [ # 0 1 ]
! WA S T E T A N K
< L O C A L . 1 > [ # 0 1 ]
! Wa s h L i q u i d E N D
< L O C A L . 1 > [ # 0 1 ]
! w a s h L i q u i d C a r t . N ON
< L O C A L . 1 > [ # 0 1 ]
! WR O N G WA S H C A R T .
* * Wa s h i n g l i q u i d * *
REMOTE
REMOTE
END