4-17
Cutting out Data with Register Marks
4
Ex
tended
Functions
– Cutting –
When Cutting Failed
Checking the Sensor for the Register Mark Detection
1
Press the
key in LOCAL to select cutting
mode.
2
Press the
key.
3
Press
to select [MAINTENANCE].
4
Press the
key twice.
5
Press the
key.
• Light pointer will be lit.
6
Press
to move the light pointer to the register mark detection
position.
• The register mark detection position should be at least 1 mm away from a register mark.
• You cannot check the response correctly by moving the head or medium manually. Be sure to
follow the steps below to check the response.
• For conditions of an already printed register mark, refer to "Notes on Inputting Data with Register
• The setting values are kept in memory even when the power is turned OFF.
• The settings performed here for type and length of the register mark are reflected in the settings of
"Setting Register Mark Detection" (
• The detection speed selected here will be used in the register mark detection operations thereafter.
• The pointer offset value and sensor gain setting value selected by this operation are not initialized by
• The origin set here is registered as the origin for normal printing/cutting. If changing the
origin after completion of confirming the register mark sensor, perform the operation in
P.2-33 "When Changing the Origin".
< LOCA L .
C
>
[ # 0 1 ]
CUT 1 ( 3 0 /
6 0 /
0 . 3 0 )
FUNCT I ON
C
SE TUP
< ENT >
FUNCT I ON
C
MA I NT ENANCE
< ENT >
MARK SENSOR
SENSOR CHECK
< e n t >
MARK SENSOR
S I Z E
= 1 0mm
1 mm or more
away
Mark detection
position
Register mark:
Type 1
Register mark:
Type 2
Summary of Contents for CJV30-100
