Cutting out Data with Register Marks
4-21
4
Ex
tended
Functions
– Cutting –
Adjust the Sensitivity (Light Intensity) of the Mark Sensor LED (Automatically)
If an error occurs frequently in register mark detection, a possible cause is an improper sensitivity of the mark
sensor LED. In this case, adjust the sensitivity (light intensity) of the mark sensor LED.
1
Make sure that the machine is in cutting mode.
• If the machine is in printer mode, press the
key to
switch the mode to cutting mode.
2
Confirm that the mark sensor is located just above a
plain area (non-printed area) of the medium.
• If the mark sensor is not located just above a plain area,
correct the location by pressing
.
3
Press the
key.
4
Press
to select [MAINTENANCE].
5
Press the
key twice.
6
Select [LEVEL ADJUST] by pressing
.
7
Press the
key.
8
Press the
key after the number displayed on the screen is stabilized.
• If all digits of the number cannot be stabilized, press the
key when the leftmost digit of the
number is fixed.
• The adjusted value is registered and the machine returns to LOCAL.
• Pressing the
key enables you to move the cutter unit manually.
• Make sure that the medium is clean and white, and locate the medium directly under the sensor.
• The value registered in [LEVEL ADJUST] will not be initialized even if the procedure described in P. 4-
37 "Initializing the Settings" is performed.
< LOCA L .
C
>
[ # 0 1 ]
CUT 1 ( 3 0 /
6 0 /
0 . 3 0 )
FUNCT I ON
C
SE TUP
< ENT >
FUNCT I ON
C
MA I NT ENANCE
< ENT >
MARK SENSOR
SENSOR CHECK
< e n t >
MARK SENSOR
L EVE L AD J US T
< e n t >
L EVE L AD J US T
OUT :
* * * *
I N :
* * * *
Summary of Contents for CJV30-100
