MIMAKI CJV30-100, Operating Manual

Page: 116 / 274

4-6
Notes on Inputting Data with Register Marks
There are some limitations on preparing data with register marks.
In order to make full use of this function, read the following instructions carefully and prepare data with register
marks properly.
Size of the Register Marks
Refer to "The Size of a Register Mark Suited for the
Distance between the Marks" (
P.4-8) for the
relationship between the data and the length of one
side of a register mark.
The Area Where Register Marks and Designs Can Be Arranged
• The TP1 starting position must be at least 20 mm away from the front end of the medium.
• The TP2 end position must be at least 30 mm away from the rear end of the medium.
Register mark: Type 1
Register mark: Type 2
• The register mark described here is intended to detect the medium skew and the lengths along the X
and Y axis. It is not a mark for trimming.
0.3~1.0mm
4~40mm
Design layout
available area
Effective cut area
(Normal)
Effective cut area
(Expand)
Pinch roller
30 mm or more
X: Between 50 to 3,000 mm
20 mm or more
Y: 50 mm or more
Design layout
available area
Effective cut area
(Normal)
Effective cut area
(Expand)
Pinch roller
30 mm + (Mark length/2) or more
X: Between 50 to 3,000 mm
20mm + (Mark length/2) or more
Y: 50 mm or more
Keep the marks away from
the pinch rollers.