MIMAKI CJV30-100, Operating Manual

Page: 141 / 274

Changing the Order of Cutting
4-31
4
Ex
tended
Functions
– Cutting –
Procedure for SORTING
1
Transmit data.
• The size of the data that has not been processed yet in the reception buffer is displayed. Cutting (plotting
with a pen) is not performed. The processed line segments are stored in the sorting buffer.
2
When data transmission has been complete, the waiting
time until cutting starts is displayed.
• The remaining time is displayed in units of seconds.
• When no data is received while waiting for the start of cutting, the counter counts down.
3
Perform auto-feeding.
• If [AUTO FEED:ON] was selected in Step 9 of Setting the SORTING( P.4-29), AUTO FEED will be
performed.
• Before starting of the cutting operation, feed the medium by the amount for the cutting. If the amount of the
cutting of the medium is not fed, [ERROR 15-C AUTO FEED] is displayed.
• After replacing the medium with a longer one, perform data transmission or cut the data into pieces
according to the specified number ( P.4-42).
4
Start cutting.
• The already cut data is displayed in percentage.
5
When the cutting has been completed, the screen goes to
the remote mode.
• When sorting is [ON], after receiving the data to be cut, the cutting operation will not start until it
completes the operation of the data receiving and the sorting process.
However, in the following situation, perform sorting and cutting without waiting.
When the sorting buffer is full of data (about 540,000 line segments)
When cutting conditions, such as Tool number, SPEED, PRESSURE, have been changed
When a feed command or origin change command has been executed
* REMOT E . C * < 1 0 0 KB >
* * SORT I NG * *
* REMOT E . C * < 1 0 0%>
* * P LOT * * 0 9 s
* REMOT E . C * < 1%>
* * SORT I NG * *
* REMOT E . C * < 1 0 0%>
* * SORT I NG * *
* REMOT E . C * [ # 0 1 ]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )