5
SYMBOLOGY
Volts
Direct Current
Alternating Current
Amps
Hertz
Read operator’s manual
WARNING
Risk of Electric Shock
Overload indicator
Overtemperature indicator
Grounding terminal
BFP
Backfeed Protected
Intertek’s ETL Listing for
Canada and U.S. Conforms To UL
STD 1012 Certified To CSA STD
C22.2 No. 300
ASSEMBLY
WARNING
Recharge only with the charger
specified for the battery. For spe
-
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push the battery latch lock
to the side and squeeze the battery latch lever. Pull
the battery pack away from the machine.
To
insert
the battery, slide the pack into the body of
the machine. Make sure it latches securely into place
GENERAL
OPERATION
Power Supply Capacity
Make sure the power supply can supply enough
continuous (running) and surge (starting) watts for
the items being powered at the same time.
1. Select the items to be powered at the same time.
2. Total the continuous (running) watts of these items.
This is the amount of power the power supply must
produce to keep the items running. See wattage
reference chart.
3. Estimate how many surge (starting) watts will be
needed. Surge wattage is the short burst of power
needed to start electric motor-driven tools or ap
-
pliances such as a circular saw. Because not all
motors start at the same time, total surge watts
can be estimated by adding only the item(s) with
the highest additional surge watts to the total rated
watts from step 2.
Power Management
To prolong the life of the power supply and attached
devices, it is important to take care when adding
electrical loads to the power supply. There should be
nothing connected to the power supply outlets before
starting the machine. The correct and safe way to
manage power supply power is to sequentially add
loads, as follows:
1.
With nothing connected to the power supply, start
the machine (see "Arming the Machine").
2. Plug in and turn on the first load, preferably the
largest load.
3. Permit the power supply output to stabilize (power
supply runs smoothly and attached device oper
-
ates properly).
4. Plug in and turn on the next load.
5. Again, permit the power supply to stabilize.
6. Never add more loads than the power supply ca
-
pacity. Take special care to consider surge loads
in power supply capacity as previously described.
Application/
Equipment
Estimated
Watts*
Estimated
Starting
Watts*
Job Site
Electric Drill - 3/8"
600
1000
Work Light
1000
1000
Reciprocating Saw
960
1920
Circular Saw - 7-1/4"
1400
2300
Miter Saw - 10"
1900
3379
Air Compressor - 1/4 HP
970
1600
Airless Sprayer - 1/3 HP
600
1200
Radio
50
50
M18™ Rapid Charger
330
330
Emergency/Home Standby
Lights (qty. 4 x 75 W)
300
300
Microwave
1000
1000
46" Flat Panel Television
190
190
Satellite Receiver
250
250
Portable Fan
40
120
Heater
1300
1300
Laptop
250
250
*Wattages listed are approximate.
Check tool or appliance for actual wattage.