Milnor COLFM 111, Installation And Service

Page: 38 / 104

PELLERIN MILNOR CORPORATION
Table 1: Parts List for Figure 1 and Figure 2
Find the assembly for your machine and the letter shown in the "Item" column. The components for your
machine will show this letter or the word "all" in the "Used In" column. The numbers shown in the "Item"
column are those shown in the illustrations.
Used In Item Part Number Description/Nomenclature Comments
Assemblies
all A ALC420223 All mounting hardware except laser
manufacturer components.
Components
A 10 04 24176 LASER TARGET FRAME
A 20 04 24177 LASER TARGET TUBE RAIL MTG Use with tubing type vertical
frame member.
A 30 04 24146 LASER MTG CHANNEL
A 40 W4 24180 LASER MOUNTING POST WLMT
A 50 27A035C U-BOLT 3/8-16X5.36 #0127316
A 60 15U246 FLATWASHER 1"ODX25/64IDX1/8"30
A 70 15U255 LOCKWASHER MEDIUM 3/8 ZINCPL
A 80 15G205 HXNUT 3/8-16UNC2B ZINC GR2
A 100 15A002A CARBOLT 1/4-20UNC2X3/4 ZINC GR
A 110 15K046 HXCAPSCR 1/4-20 UNC2A X 2"GR5
A 120 17N058 HEXRIVNUT 1/4-20 UNC-2B #2520-
A 130 15U185 FLATWASHER(USS STD) 1/4" ZNC P
A 140 15U180 LOCKWASHER MEDIUM 1/4 ZINCPL
A 150 15G178 1/4"-20 HEXFLANGE NUT ZINC
A 160 15N125 RDMACSCR 10-24UNC2AX1/2 ZC GR2
A 170 15U135 FLATWASH#10 .4370DX.203IDX.04T
A 180 15G126SZ HXLOCKNUT 10-24 UNC STL/ZNC
A 190 15P011 TRDCUT-F PANHD 10-24X1/2 NIKST
A 200 04 24178 LASER TARGET J-RAIL MTG Use with J-rail vertical frame
member.
all 210 09RLE0001 Banner L-Gage LT7 Laser and mounting
bracket
all 220 09RLE0001B Mounting Bracket and included fasteners
all 230 09RLE0001R 50 meter Retro Reflector
all 240 09RLE0001C Multi-conductor cable and connector—30 foot
(7.6 meters) length
Tube -- A type of frame used on certain shuttles
J-rail -- A type of frame used on certain shuttles
2.
Electrical Connections
The electrical cable provided with this system has a pre-wired connector on one end that attaches
to the laser. Shuttles manufactured after February 2011 have the control box end of the cable pre-
wired also. The cable is secured to the control box. If the shuttle was not provided with the cable
pre-wired, make connections as explained below. Do not connect the cable to the laser until the
wiring in the electric cabinet is completed.
1. Determine the best route for the cable. Ensure that:
• objects cannot strike the cable,
• there is sufficient slack on each end to reach the connection points.
34