ALU-TP-
1
58
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
Industrial Aluminum Tripod - Extends from 3.5 to 10 feet
Instruction Manual
TRI
POD ASSEMBLY
The
tri
pod assembly consists of
3
parts:
1.
T-bracket
2.
Extension Pole
3.
Leg Base
To assemble quadpod:
1.
Begin by placing the
legs
in a flat level area.
2.
Extend the legs to hold up the tripod
.
3.
Loosen legs and slide down until fully deployed. Tighten hand screw.
4.
Finally, attach
T-bracket
over
the
top Extension Pole and tighten hand
screw.
Use appropriate measures to attach equipment to the top of T-
bracket
. Predrill holes through top and
bottom and utilize bolts for mounting heavy equipment.
WARNING:
Use caution before tilting
tri
pod with a heavy load. For heavy loads, it is recommended
to remove the T-
bracket
prior to transporting! Failure to do so may cause serious injury. Larson
Electronics shall not be held liable for injuries caused by misuse.
1.
Place tower in desired location that is flat and able to support the
tri
pod without falling over.
2.
Loosen hand screw and lower legs until firmly stabilizing
tri
pod.
3.
Tighten hand screw to secure legs.
4.
With help, place the T-
bracket
over top pole and tighten hand screw.
Light weight devices can be attached by tilting
tri
pod toward the ground with the legs up. Attach T-
bracket
to pole, tighten hand screw and tilt back to its vertical position. DO NOT tilt
tri
pod while
extended to max height. It is recommended to have another person hold the
tri
pod while tilting
vertically.
For heavy equipment, use a ladder and extra help for attaching T-
bracket
to pole.
Double check that all hand screws are tight before continuing use of the
tri
pod tower.
