Milnor COLFM 111, Installation And Service

Page: 40 / 104

PELLERIN MILNOR CORPORATION
Figure 5: Connections—Previously Installed Shuttle
Connection Points in Processor Box 24 VDC Power Supply in Low Voltage Box
Ground Terminals in Low Voltage Box Legend
.
1. MTA30, pin 5—connection point for White
wire (TX+)
2. MTA30, pin 8—connection point for Green
wire (RX+)
3. 24VDC power supply—The 24VDC side is
wire #102. Trace this wire to an available
terminal and connect the red wire (Vcc) at
this location.
4. Ground terminals—connect blue wire (Gnd)
and cable shield to any available ground
terminal.
3.
Configure, Align, and Program
These instructions apply specifically to Banner L-Gage LT7 laser device. You received a manual
with this device. Review the safety information in this manual. The manual provides more
information than necessary to implement the laser positioner system for the shuttle. The following
sections give the pertinent instructions. You can find detailed information in the Banner manual.
Display or Action Explanation
M M M M
Energize the shuttle (at the MultiTrac or Drynet console). This
will also apply power to the laser.
H
H H
H
Set the shuttle to the Manual mode (at the stationary shuttle
control panel). This will take the shuttle off line.
Perform the procedures in this section with shuttle power on, but with the machine off line. Use
extreme care when you work in or near the shuttle path.
3.1.
Laser Configuration
—Required configuration settings:
Serial interface: RS422
36