Milnor COLFM 111, Installation And Service

Page: 47 / 104

How to Test Traversing Shuttle Stop Positions
PELLERIN MILNOR CORPORATION
5. Enter cake data for a dry code that the device at the test position can receive. Typically, a
dryer can receive all but the no-dry code and a no-dry station can only receive the no-dry
code. The shuttle will move toward the test position.
6. As soon as the shuttle stops at the test position and before a transfer can occur, stop the
machine (
0
).
7. Remove the object from the shuttle bed.
8. Set the shuttle to the manual mode (
H
) and start the machine (
1
).
9. Check shuttle alignment and adjust as necessary.
10. Set the shuttle to automatic mode (
B
). The shuttle will return to the home position.
11. Repeat as necessary.
4.
Test a non-Home Position Where the Shuttle Receives Goods
If an installation has two loading positions for the shuttle, at least one of these will not coincide
with the home position. In such a case, the shuttle will likely be loaded by a storage device such
as an elevating shuttle. To cause the traversing shuttle to move to the non-home loading position:
1. Set the traversing shuttle to the automatic mode (
B
).
2. Place a rag or similar object in the center of the top belt of the device at the test position (the
non-home device that loads the traversing shuttle).
3. Energize and start this device (
M
,
1
). The storage device bed will run until the photo eye is
blocked. The Cake Data prompt will appear on the display for this device.
4. Enter cake data. This will summon the traversing shuttle.
5. As soon as the traversing shuttle stops at the test position and before a transfer can occur, stop
the loading device (
0
).
6. Remove the object from the loading device bed.
7. Set the traversing shuttle to the manual mode (
H
) and start the machine (
1
).
8. Check shuttle alignment and adjust as necessary.
9. Set both the loading device and the traversing shuttle to automatic mode (
B
). The traversing
shuttle will return to the home position.
10. De-energize the loading device (
m
).
11. Repeat as necessary.
— End of BIVSRC01 —
43