Miller Auto-Axcess E Digital, Owner'S Manual

Page: 57 / 164

General
OM-257 675 Page 51
Click on the invert signal check box, Enable digital filter, and fill in a number for the minimum low and high signal widths for your robot I/O signal deboun-
cing. The units are 0.1 ms, so 10 gives 1 ms of filter.
Click “Apply to all” to make the setting apply to all of the DI pins.
Click back on the 6050 block, click on the Network tab, and set the IP address to be compatible with the power source. If you are using the Axcess E port
A direct connect, use 169.254.0.1. If you are connecting through a switch, get an appropriate static IP address for the network from your IT staff. After
connecting the ADAM − 6050 block to the power source, enter that address on the Robot Remote IO web page in the Axcess E web pages, test it, then
cycle the Axcess E power.
.
Ports A and B on the power source cannot be on the same subnet or the Remote IO block may not connect.