Panel Functions 139
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual logiJET T4-2 /T6-2 /RFID
Edition 2.2
9.32. Adjusting the Tear Off Position (Option: Cutting Position)
The tear off position
is identical to the detected gap position, i.e. with the
perforation or the start of the label. With this function a fine setting of the tear off
position is carried out. The setting range for the offset is approximately 0 to -4.2
mm.
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
[Engine ]
[Printspeed ]
[TearOff Menu ]
[TearOff Mode ]
[TearOff Position ]
[Position: - 2.0 mm ]
[Position: - 2.5 mm ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The ENTER key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[TearOff Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[TearOff Position ] is displayed.
The currently set value is displayed.
Press the NEXT or PREVIOUS key until
the desired offset is displayed.
The tear off position is shifted 0.5 mm
in feed direction.
In addition this new value can be saved
as setup value (using the ENTER key).
After this decision turn the printer
ONLINE again: Press the ONLINE key
longer than 2 seconds.
If a cutter is installed and activated, the concerning panel function Cutting Position has to be used.
