PlatinumRAID Owner’s Manual
5.11 Serial Port Configuration
To set or change the RAID subsystem communications port configuration, Scroll to the
“COMA
Configuration”
selection and press
ENT
. The baud rate/stop bits setting screen will appear.
Set the new desired values, and press
ENT
. After completing the modification, the confirmation
screen will be displayed and then press
ENT
to accept the function. The following are the
acceptable values for each respective field:
Monitored Item
Warning Condition
Baud Rate
1200,2400,4800,9600,19200,38400, 57600, 115200
Stop Bits
1,2
Parity
None
5.12 Reset Controller
To reset the RAID subsystem, select
“Reset
Controller”
and then press
ENT
. The
confirmation screen will be displayed and
then press
ENT
to reset.
6. Additional System Functions (F)
6.1 Ultra320 target Configuration functions
6.1.1 QAS
The PlatinumRAID supports QAS
(Quick Arbitrate and Select) function
of the Ultra320 SCSI protocol. When
implemented with a compatible Host Bus
Adapter, QAS reduces SCSI command
overhead and may provide improved
performance. QAS is optional and, when
enabled, requires the initiation and
detection of a QAS REQUEST message
from a compatible Ultra320 host bus
adapter before starting. Press
ENT
to
enter the Main menu. Press
UP/DOWN
to select the U320 SCSI Target option,
and press
ENT.
6.1.2 Auto Speed Control
The PlatinumRAID can automatically
reduce SCSI speed if the SCSI host
connection is not stable at the negotiated
speed. This option is enabled by default,
and should not be modified unless
instructed by MicroNet Technical
Support.
5-RAID Controls-LCD/Terminal
F
END
C ontroll erTemp.
BackPl ane Temp.
Fan Spe ed (RPM)
Power +12V
Power +5V
Power +3.3V
Power +1.5V
U320 SCSI
Target Config
Clear Event
Buffer
Confirm Change
ENT:Yes, ESC:No
Main Processor
CPU Cache Size
CPU Data Cache
System Memory
Firmware Version
Serial Number
Controller Name
Channel 0 QAS
*Disable
Confirm Change
ENT:Yes, ESC:No
<Enabled, Disabled>
Ethernet
Configuration
DHCP Function
*Enabled
Manual IP Address
*192.168.0.100
SMTP Port Number
*25
<xxx.xxx.xxx.xxx>
Confirm Change
ENT:Yes, ESC:No
<Enabled, Disabled>
Confirm Change
ENT:Yes, ESC:No
View System
Events
Hardware Monitor
Information
Show System
Information
Email Notification
Config
SNMP
Configuration
HTTP Port Number
*80
Telnet Port Number
*23
Ethernet Mac Address
(Reserved)
Confirm Change
ENT:Yes, ESC:No
Confirm Change
ENT:Yes, ESC:No
Confirm Change
ENT:Yes, ESC:No
Confirm Change
ENT:Yes, ESC:No
IMPORTANT: Controller Reset can only be
performed if no host or drive activity is present.
!
