Microlife aponorm Professionell 47034, Manual

Page: 19 / 48

19
EN
aponorm ® Professionell
11. Error Messages
If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. «
ERR 3 », is displayed.
* Please consult your doctor, if this or any other problem occurs
repeatedly.
Error Description Potential cause and remedy
« ERR 1 » Signal too
weak
The pulse signals on the cuff are too
weak. Re-position the cuff and repeat
the measurement.*
« ERR 2 » Error signal During the measurement, error signals
were detected by the cuff, caused for
instance by movement or muscle
tension. Repeat the measurement,
keeping your arm still.
« ERR 3 » No pressure
in the cuff
An adequate pressure cannot be gener-
ated in the cuff. A leak may have
occurred. Check that the cuff is correctly
connected and is not too loose. Replace
the batteries if necessary. Repeat the
measurement.
« ERR 5 » Abnormal
result
The measuring signals are inaccurate
and no result can therefore be displayed.
Read through the checklist for
performing reliable measurements and
then repeat the measurement.*
« ERR 6 » MAM Mode There were too many errors during the
measurement in MAM mode, making it
impossible to obtain a final result. Read
through the checklist for performing reli-
able measurements and then repeat the
measurement.*
« HI » Pulse or cuff
pressure too
high The pressure in the cuff is too high (over
300 mmHg) OR the pulse is too high (over
200 beats per minute). Relax for 5
minutes and repeat the measurement.*
« LO » Pulse too
low The pulse is too low (less than 40 beats
per minute). Repeat the measurement.*
13.
)
If you think the results are unusual, please read through the
information in «Section 1.» carefully.
12. Safety, Care, Accuracy Test and Disposal

Safety and protection
Instrument care
Clean the instrument only with a soft, dry cloth.
x
This instrument may be used only for the purpose described
in this booklet. The manufacturer cannot be held liable for
damage caused by incorrect application.
x
This instrument comprises sensitive components and must
be treated with caution. Observe the storage and operating
conditions described in the «Technical Specifications»
section!
x
Protect it from:
water and moisture
extreme temperatures
impact and dropping
contamination and dust
direct sunlight
heat and cold
x
The cuffs are sensitive and must be handled with care.
x
Only pump up the cuff when fitted.
x
Do not use the instrument close to strong electromagnetic
fields such as mobile telephones or radio installations.
x
Do not use the instrument if you think it is damaged or
notice anything unusual.
x
Never open the instrument.
x
If the instrument is not going to be used for a prolonged
period the batteries should be removed.
x
Read the further safety instructions in the individual
sections of this booklet.
Ensure that children do not use the instrument unsuper-
vised; some parts are small enough to be swallowed.
14.
11402 Profes_Gebrsanw_innen RZ B.indd 19 03.08.2010 16:45:28 Uhr