MICRO-EPSILON reflectCONTROL RCS, Instruction Manual

Page: 103 / 134

Description of the “Evaluation” View
Page 103
G “Start measurement” button: Click on this button to perform a measuring operation, calculate
the measurement results and display the point cloud and measurement results of the currently
selected measuring program in the 3D-View.
H Results display: The measurement results of the currently selected measuring program are dis-
played. Here, you can select which measured values are to be made available later for calcula-
tion, OK/nOK assessment, logging and output (see Chapter
3.16.8 ).
I Status bar: Status and error messages are displayed in the status bar (see Chapter 8.1 ).
1 Input data: Use this selection field to select the reference plane and input point cloud for the pro-
gram (see also Chap.
3.16.3 ).
2 Edge threshold: This threshold defines the minimum deviation of the surface from the reference
plane in order to detect the edge points. If the edges are skewed or if 3D points of the side walls of
the pad are available in the measurement data, this parameter can be used to alter the position of
the calculated edge points relative to the reference plane.
3 3D-View: The 3D-View shows the fitted pad (orange). The points that were used to calculate the
pad are shown in blue. The input plane is shown in yellow, and the reference plane defined by the
input plane and edge threshold is shown in orange.