Page 45
Cleaning
optoCONTROL CLS1000
6.
Cleaning
We recommend cleaning the sensor at regular intervals.
Dry Cleaning
This can be accomplished with an anti-static lens brush or by blowing off the sensors with dehumidified, clean, oil-free
compressed air.
Wet Cleaning
Use a clean, soft, lint-free cloth or lens cleaning paper and lens cleaner to clean the lenses. Never use commercially
available glass cleaner or other cleaning agents.
7.
Disclaimer
All components of the device have been checked and tested for functionality in the factory. However, should any defects
occur despite careful quality control, these shall be reported immediately to MICRO-EPSILON or to your distributor /
retailer.
MICRO-EPSILON undertakes no liability whatsoever for damage, loss or costs caused by or related in any way to the
product, in particular consequential damage, e.g., due to
- non-observance of these instructions/this manual,
- improper use or improper handling (in particular due to improper installation, commissioning, operation and mainte-
nance) of the product,
- repairs or modifications by third parties,
- the use of force or other handling by unqualified persons.
This limitation of liability also applies to defects resulting from normal wear and tear (e.g., to wearing parts) and in the
event of non-compliance with the specified maintenance intervals (if applicable).
MICRO-EPSILON is exclusively responsible for repairs. It is not permitted to make unauthorized structural and / or techni-
cal modifications or alterations to the product. In the interest of further development, MICRO-EPSILON reserves the right
to modify the design.
In addition, the General Terms of Business of MICRO-EPSILON shall apply, which can be accessed under Legal details |
Micro-Epsilon
https://www.micro-epsilon.de/impressum/
. For translations into other languages, the German version shall
prevail.
8.
Service, Repair
If the controller or sensor is defective:
- Please send us the affected parts for repair or exchange.
If the cause of a fault cannot be clearly identified, please send the entire
measuring system to:
MICRO-EPSILON Eltrotec GmbH
Manfred-Wörner-Straße 101
73037 Göppingen / Germany
Tel: +49 (0) 7161 / 98872-300
Fax: +49 (0) 7161 / 98872-303
[email protected]
www.micro-epsilon.com
