Page 5
Safety
optoCONTROL CLS1000
1.
Safety
System operation assumes knowledge of the operating instructions.
1.1
Symbols Used
The following symbols are used in these operating instructions:
Indicates a hazardous situation which, if not avoided, may result in minor or moderate injury.
Indicates a situation that may result in property damage if not avoided.
Indicates a user action.
i
Indicates a tip for users.
Measurement
Indicates hardware or a software button/menu.
1.2
Warnings
Connect the power supply and the display/output device according to the safety regulations for
electrical equipment.
> Risk of injury
> Damage to or destruction of the sensor and/or the controller
The supply voltage must not exceed the specified limits.
> Damage to or destruction of the sensor and/or the controller
Avoid shocks and impacts to the sensor and controller.
> Damage to or destruction of the sensor and/or the controller
Never fold the sensor (optical fiber) and do not bend the sensor in tight radii.
> Damage to or destruction of the sensor, failure of measuring device
Protect the ends of the optical fiber against contamination (use protective caps).
> Functionality impaired due to contamination
> Failure of the measuring device
1.3
Notes on CE Marking
The following apply to the optoCONTROL CLS1000:
- EU Directive 2014/30/EU
- EU Directive 2011/65/EU
Products which carry the CE mark satisfy the requirements of the EU directives cited and the relevant applicable harmo-
nized European standards (EN). The measuring system is designed for use in industrial and home applications.
The EU Declaration of Conformity is available to the responsible authorities according to EU Directive, Article 10.
