Mhouse MhouseKit WG2S, Instructions For Installation And Use Manual

Page: 59 / 132

English
Photocells PH100
Model/type
Product type
Adopted technology
Detection capacity
TX transmission angle
RX reception angle
Useful range
Power supply / output
Absorbed power
Max. cable length
Possibility of address assi-
gnment
Ambient operating temperature
Use in particularly acid, saline or
potentially explosive atmospheres
Assembly
Protection rating
Dimensions/weight
Presence detector for automations of automatic gates and doors (type D according to standard
EN 12453) comprising a transmitter “TX” and receiver “RX
Optical, by direct interpolation of TX-RX with modulated infra-red rays
Opaque objects located on the optical axis between TX and RX, larger than 50 mm and moving
slower than 1.6 m/s
20° approx.
20° approx.
10 m for maximum TX-RX misalignment ±5° (the device can signal an obstacle even in the event
of particularly adverse weather conditions
The device can only be connected to the “ECSBus” networks from which it receives mains power,
and sends the output signals
1 ECSBus unit
Up to 20 m (observe warnings regarding the minimum section and type of cables)
UP to 7 detectors with protection function and 2 with opening command function
Automatic synchronisation prevents interference between the various detectors
-20 ÷ 50°C
No
Vertical, wall-mounted
IP44
64 x 89,2 h 29 mm / 60 g
Product type
Adopted technology
Maximum start-up torque
Nominal torque
No-load speed
Speed at nominal torque
Stroke
Maximum frequency of cycles
Maximum frequency of cycles
Application limits
Power supply
Max. absorbed rated power
Ambient operating temperature
Use in particularly acid, saline or
potentially explosive atmospheres
Assembly
Protection rating
Dimensions / weight
English – 25
Electromechanical gearmotor for automations of automatic gates and doors
24Vdc motor, helical gear reducer; mechanical release
1400N
460N
21 mm/s
17 mm/s
330 mm
30 cycles/hour
18 minutes approx.
The structural design of this product makes it suitable for use on gates with a weight up to 250 kg
or leaf width up to 2.2 m and opening angle up to 130°
24Vdc
1,1A,; on start-up, maximum current is 3.5 A for a maximum time interval of 2 s
-20 ÷50°C (gearmotor efficiency is reduced at low temperatures)
No
Horizontal with specific fixing plates
IP54
729 x 85 h 100/ 6kg
Straight gearmotor for WG1SK swing gates
TECHNICAL SPECIFICATIONS OF PRODUCT COMPONENTS
The product WG2S is produced by Nice S.p.a. (TV) I. In order to improve its products, NICE S.p.a. reserves the right to modify the technical charac -
teristics at any time without prior notice. In any case, the manufacturer guarantees their functionality and fitness for the intended purposes. Note: all
technical specifications refer to a temperature of 20°C.