Mhouse MhouseKit WG2S, Instructions For Installation And Use Manual

Page: 40 / 132

English
6 – English
INSTALLATION: ASSEMBLY AND CONNECTION OF COMPONENTS
––– STEP 5 –––
IMPORTANT!
- The following assembly phases show installation of a gearmotor
model WG1SK.
- To ensure correct system operation, mechanical stops must be
mounted on the floor or wall at the maximum leaf opening and closing
points. Note - These stops are not supplied in the pack and are not
part of the Mhouse product range.
WARNINGS
• Incorrect installation may cause serious physical injury to those
working on or using the system.
• Before starting automation assembly, make the preliminary
checks as described in STEP 3.
5.1 - INSTALLING THE GEARMOTOR WG1SK
To secure the gearmotor, proceed as follows:
01. Select the fixing position, observing the specifications in paragraph
3.1 “Preliminary checks”;
02.
Ensure that the fixing surface is perfectly smooth, level and sufficient -
ly compact. WG1SK is not supplied with fixing devices, which must
be chosen also on the basis of the fixing surface material.
03.
Lay the duct for routing the electric cable (
fig. 8
);
04. To construct the rear supports, assemble the two brackets and rear
plate as shown in fig. 9 ;
05. The brackets and rear plate can be assembled in different ways: to
obtain the various values of “C” see fig. 10 ;
06. To construct the front support, assemble the bracket and front plate
as shown in
fig. 11
;
07. Remove the rear cover of the gearmotor by loosening the two screws
in fig. 12 ;
08. Move the leafs to the closed position;
09.
With reference to the previously calculated position “B” (
fig. 4
and
5
),
place the rear support on the fixing surface, in the envisaged posi -
tion;
Caution! - check the positions in fig. 15.
10. Trace the drilling points of the rear support using the support as a
reference Using a drill make four holes on the surface for insertion
of 4 plugs of at least 8 mm (not supplied). Fix the plate with suitable
screws and washers ( fig. 13 );
11. Ensure that the plate is perfectly level (the slots on the bracket enable
small corrections to alignment, as shown in (
fig. 14
);
12. Place the front support as shown in fig. 15 ;
13. Provisionally secure the front support to the leaf with a clamp ( fig. 16 );
14. Lift the gearmotor and insert the fork in the hole of the front support;
15. Keeping the gearmotor raised, pull to open the leaf and align the hole
on the rear plate with the hole on the gearmotor. Fix the gearmotor
to the rear support [A] using screw [B] , nut [C] and washer [D] ( fig.
17
);
16. Tighten the nut fully down then loosen by approx. half a turn to enable
rotation of the gearmotor on its support;
17. Secure the gearmotor to the front support, tightening the screw [ E]
and washer [ F ], then tighten the screw fully down ( fig. 18 );
18. Unlock the gearmotor again using the release keys (see paragraph
11.3 - User’s Guide ).
6
a
e f h
b c d
g
c
g
f
e
D
7
A B C
E D F
D
G G