Mhouse MhouseKit WG2S, Instructions For Installation And Use Manual

Page: 57 / 132

English
LED OPEN [C]
Off
On
Status
Everything OK
OPEN input activated
Action
OPEN input not active
This is normal only if the device connected to the OPEN input is
active.
LED STOP [B]
Off *
On
Status
STOP input activated
Everything OK
Action
Check the devices connected to the STOP input
STOP input active
Quick flashes
1 flash
1 second pause
1 flash
2 flashes
1 second pause
2 flashes
3 flashes
1 second pause
3 flashes
4 flashes
1 second pause
4 flashes
Status
ECSbus error
Photocell activated
“Gearmotor force” limiting device activated
STOP input activated
Action
At the beginning of the manoeuvre the devices present do not corre -
spond with those recognised; check and eventually carry out the learn -
ing procedure (10.3.3 “Recognition of other devices”). One or more
devices may be faulty; check and, if necessary, replace them.
At the start of the manoeuvre, one or more photocells do not enable
movement; check to see if there are any obstructions. During the
movement if there is an obstruction no action is required.
During the movement, the gate experienced excessive friction; identify
the cause.
At the start of the manoeuvre or during the movement, the STOP input
was activated; identify the cause.
TABLE 12
English – 23
10.6.2 - Flashing light
During a manoeuvre the flashing light flashes every second; in case of
anomalies the light flashes at more frequent intervals (half a second); the
flashes are repeated twice with an interval of one second; see Table 12 .
10.6.3 - Control unit
The LEDs on the control unit provide particular signals to report on the
normal operation and on possible faults; see Table 13 .
47
D
E
F
C B
A
LED ECSBus [A]
Off
On
One flash per second
2 long flashes
1 flash every 5 seconds
Series of flashes separated
by a pause
Quick flash
Status
Fault
Serious fault
Everything OK
Input status variation
Robotics in “standby” mode
ECSBus short circuit
Action
Check that the unit is powered; check that the fuses have not
been activated; if this is the case check the cause of the fault
and replace them with other fuses with the same characteristics.
There is a serious fault; switch off the control unit for a few sec
-
onds; if the status persists there is a fault and the electronic
board must be replaced.
Control unit works correctly
A variation to the status of the inputs: OPEN, STOP, activation of
the photocells, or when the radio transmitter is used, is normal.
Everything OK; when the control unit receives a command nor
-
mal operation is restored (with a short delay).
An overload has been detected therefore the power to the ECS -
Bus switched off. Check by disconnecting the devices one at a
time.
To restore power to the ECSBus simply send a command, for
example with a radio transmitter.
TABLE 13 (fig. 47)
The same signal as for the flashing light, see Table 12 .