MHG Heating ThermSelect, Assembly, Commissioning And Maintenance Instructions

Page: 36 / 100

6. Assembly
ThermSelect®
36/100
6 Installation
6.1 Safety during assembly
WARNING!
Risk of injury due to improper assembly!
Improper assembly leads to serious personal injuries
and property damages.
Therefore:
-
Assembly and startup must take place by an autho-
rised heating and/or air conditioning professional.
-
Provide sufficient installation clearance before be-
ginning with the work.
-
Be careful with open components with sharp edges.
DANGER!
Risk to life through electrical current!
Contact with live components can cause serious inju-
ries.
Therefore:
-
Work on electrical systems may only be performed
by professional electricians.
-
Turn off electric power before beginning the work
activities and secure against being turned on again.
6.2 Requirements on the
erection location of the heat
pump
Before doing the installation, make sure that the erection location
meets the following requirements:
-
Operating tempe5 °C to +30
-
Dry, frost-proof, good air supply and ventilation
-
No heavy dust build-up
-
No high humidity
-
No air pollution through halogenated hydrocarbons (e.g. in sol-
vents, adhesives, spray cans)
-
No sulphur compounds
-
No vibrations and shocks
-
Stable, smooth and horizontal surface
NOTE!
In case of existing systems, a dirt filter must be in-
stalled on the heating side to protect the condenser.
Systems with above average temperature loads also require
consultation with MHG Heiztechnik.