Wall formwork
Mammut 350
Stop ends
Fig. 41.1
Fig. 41.2: Use M assembly lock for walls up to
60 cm thick. From 65 cm use Circo-Mammut
transition lock.
Fig. 41.3
Fig. 41.4
Fig. 41.5
Fig. 41.6
With stop end br
acket 40/60
Up to 40 cm
Half shell of the Circo circular steel
column formwork
Column clamp
Uni-tie claw
M column bracket, size 1
M column bracket, size 1
Flange screw 18
A stop end can be formed either
with a stop end bracket, column
clamp and alignment rail or a
size 1 M column bracket and
standard panels. The stop end
bracket is placed at tie hole
level and replaces the tie rod
(Fig. 41.1). Round stop ends
can be formed with the Circo
circular steel column formwork
(Fig. 41.2).
Column clamps with alignment
rails are attached at tie hole level
(Fig. 41.3). Tying is done either
outside the panels with Uni-tie
claws and tie rods (Figures 41.3
and 41.4) or through the tie
holes. Size 1 column brackets are
attached to the multifunction
profiles at tie hole level. The stop
end can be built with square tim-
bers and a facing (Fig. 41.5) or
with standard panels that match
the wall thickness (Fig. 41.6).
Tying is done through the col-
umn bracket.
Attention
Never use DW tie rods for stop
ends if these are going to be
subject to shear stress. Tying
must always be done at the
column bracket.
Description
Ref. No.
Stop end bracket 60/23 .........
29-105-60
Stop end bracket 40/60 .........
29-105-50
M column bracket, size 1 .......
79-402-13
Column clamp 21 ..................
29-402-70
Uni-tie claw ...........................
29-901-41
M assembly lock ....................
29-400-71
Transition lock
Circo-Mammut ......................
29-400-80
Up to 75 cm
With stop end bracket 60/23
(not shown)
M350-41
Technical Instruction Manual / Status November 2018
