Wall formwork
Mammut 350
The Mammut 350 panel
The large-size panels 350/250
(Fig. 5.1) and 300/250
(Fig. 5.2)
These panels are ideally suited
for vertical and horizontal use.
Since the tie holes are located
inside the panel, the 8.75 m²
forming area of the 350/250
panel requires only six ties and
the 7.50 m² forming area of the
300/250 panel only four ties.
The panels can be connected to
existing walls without alignment
rails or fillers. They can overlap
by up to 50 cm (see page M350-
39).
If 250 cm high panels are used
horizontally and mounted on
top of each other, an even joint
pattern with continuous vertical
joints is assured.
Vertical and horizontal panels
can be combined freely.
Panels with a width of 125 and
250 cm are equipped with 4
bump notches that are diago-
nally welded in, allowing exact
panel positioning without a
hammer. The panels can be posi-
tioned in all directions without a
hammer (M350 Fig. 4.6).
Description
Ref. No.
M 350 panel AL 20
350/250................................
23-005-05
M 350 panel AL 20
300/250................................
23-006-05
Fig. 5.2
Fig. 5.1
M350-5
Technical Instruction Manual / Status November 2018
