Wall formwork
Mammut 350
Substitution of ties
Fig. 48.1
Fig. 48.2
Æ
When height-extending
with two horizontal panels,
each with a maximum width of
1.25 m, and if the total form-
work height does not exceed
6.00 m, the ties in the bottom
extension panel can be replaced
by two RS 250 alignment rails
(Fig. 48.1).
Æ
When combining two
vertical M 350 panels for a total
formwork height of 7.00 m, the
top ties of the top panel can be
replaced by Uni-tie claws that
are attached above the top panel
(Fig. 48.2).
Æ
A formwork height of
8.25 m is achieved by extend-
ing a vertical M 350 panel with
another vertical M 350 panel
and a horizontal panel that is
1.25 m wide. For this configura-
tion no ties need to be installed
in the bottom tie holes of the
top panel if using alignment
rails (Fig. 48.3). The same is true
when adding another panel with
a width of 1.25 m in horizontal
position for a total formwork
height of 9.50 m (Fig. 48.4).
Fig. 48.3
Fig. 48.4
6.00 m
7.00 m
9.50 m
8.25 m
M350-48
Technical Instruction Manual / Status November 2018
