79
10.3. CONFORMITY TO INTERNATIONAL STANDARDS / ELECTRICAL SAFETY
The instrument is compliant with standard IEC/EN 61010-1
Power supply: 240 V
10.4. ELECTROMAGNETIC COMPATIBILITY
The instrument is compliant with standard IEC/EN 61326-1
11. MAINTENANCE
The instrument contains no parts that can be replaced by personnel who have not been specially trained and accredited.
Any unauthorized repair or replacement of a part by an "equivalent" may gravely impair safety.
11.1. CLEANING
If the instrument requires cleaning, disconnect it from all power sources and clean it will a mild detergent and water.
Make sure the instrument is completely dry before reconnecting it to a power source.
To clean the exterior surface, perform the following steps:
Remove loose dust on the outside of the instrument with a lint-free cloth. When cleaning the screen, be careful to avoid
scratching the transparent plastic protective screen.
Use a soft cloth dampened with water to clean the instrument.
WARNING:
To avoid any damage to the surface of the instrument, do not use any abrasive or chemical cleaning agents.
Daily Maintenance: Do not store or leave the instrument in places where the display screen will be exposed to direct sunlight for
a long period of time.
CAUTION:
To avoid damage to the instrument, do not expose it to spray, liquid, or solvent.
11.2. UPDATING OF THE INTERNAL SOFTWARE
With a view to providing, at all times, the best possible service in terms of performance and technical upgrades, Chauvin Arnoux
invites you to update the embedded software of the device by downloading the new version, available free of charge on our web
site.
Our site:
http://www.chauvin-arnoux.com
Click on "Support", then "Access the download area", then enter the name of the instrument ("
GX 1030
").
Connect the device to your PC using the USB cord provided.
The update of the embedded software depends on its compatibility with the hardware version of the instrument.
This version is indicated in SET-UP.
Attention: updating the embedded software resets the configuration and causes the loss of the stored data. As a precaution, save
the stored data to a PC before updating the embedded software.