Adding the Power-Switch and charge-PCB / USB port
1.
Install the main power switch into the switch holder.
2.
Solder the AWG 30 wire from battery positive to the prepared charge-PCB
B+ pad.
3.
Place the
charge PCB
in position
below the switch holder
.
No glue needed.
4.
Install the switch holder. Guide the wires as shown on the pictures.
5.
Solder the wires coming from the switch to the Soundboard negative pad and to the wire which
leads to the battery negative.
6.
Solder the
speaker wires
(gray) to the Soundboard. Rout the wires as shown in the picture.
7.
Place the
charge indicator LED
above the main power switch
42
