Blade holder - Emitter
Backplate
Two different
backplates
can be used. The thin one for NeoPixel setup and the thick version for
high brightness LED setup.
The thick back plate works as heat sink.
Blade stop
Two different blade stop rings can be used. A 3D
printed nylon version. Or an aluminum version.
The high brightness LED setup works only with the
aluminum blade stop!
The nylon version has a guiding grove and
slots for
five accent NeoPixel LED
. They can illuminate the
five Emitter vents.
High brightness LED setup
Mount the HB-LED directly onto the
thick backplate
. Lead the LED
wires through the backplate hole.
IMPORTANT: Only use the aluminum blade stop ring with HB-LED.
The nylon blade stop would melt!
NeoPixel setup
-
Prepare the NeoPixel connector PCB (hilt).
IMPORTANT: Only use NeoPixel connectors with low profile Pogo
pins! I recommend to use the high quality PCBs from
- Tap the three holes
in the thin back plate. Use a M1.4 tap.
-
Install the
connector holder
onto the thin Back plate. Use three
M1.4 screws.
-
Install the wired NeoPixel connector into the connector holder.
53
