Switch PCBs
1. Solder the smd switches
onto the two PCBs.
Add
AWG
34 wires
later when the Emitter is done.
2. Adjust the PCB thickness
. Sand down the PCB bottom
a bit till the switch covers fit and work perfectly.
Especially the
ACT switch PCB
should be reduced in
height. So that there is more distance between the
switch and the switch cover. Otherwise the switch could
respond too easily.
3. Install two 1.5mm brass rods
into the AUX switch
PCB
mounting holes
. Adjust the height. They should line up
with the switch PCB surface.
4.
Place both PCBs into their position.
No glue needed!
5.
Mount the switch cover A and C over the switches and
test the function
. Does it work smoothly?
Especially the AUX switch cover needs attention. It
should move nice and easy. If not, more sanding is
needed.
Switch wiring
Solder AWG 34 wires to the pads. Both GND wires can be
combined!
TIP:
Use a small (1mm grid)
connector for the switch wires to
connect with the wires coming
from the chassis.
54
