MetalMaster Chassis system 3.0, Instruction Manual

Page: 4 / 60

2.
Tools
For assembling the printed chassis parts and installing the electronic parts you need different
tools...
•
sandpaper (240 grain and 600 grain)
•
drill heads 1mm, 2mm, 3mm, 4mm
•
small slot screwdriver
•
double-sided adhesive tape (thin and foam)
•
scalpel / small cutter
•
tap M1.2 and M1.4
•
glue (Pattex repair EXTREME and Epoxy)
•
Loctite 648
•
files with diamond grid (small and medium)
•
soldering-iron and solder
•
tweezers
•
liquid rubber
•
insulating tape
•
shrink tubing
•
belt sanders small (for example Proxxon)
•
power tool (Dremel or Proxxon)
3.
Additional parts
Basic Chassis parts
•
3x M2 threaded steel rods https://www.mb-sabers.com/shop
•
1x M1.2 brass rod https://www.mb-sabers.com/shop
•
2x 40mm steel rods (1mm diameter) https://www.mb-sabers.com/shop
•
4x 95mm steel rods (1mm diameter) https://www.mb-sabers.com/shop
•
2x brass tubes 40mm x 4mm diameter https://www.mb-sabers.com/shop
•
3x M1.2 countersunk screws https://www.mb-sabers.com/shop
•
6x M2 nuts DIN934 https://www.mb-sabers.com/shop
•
4x M1.2 nut https://www.mb-sabers.com/shop
•
power switch ( TS01CQE 3A 120V ) DigiKey
•
micro USB-B or USB-C port (female) https://www.mb-sabers.com/shop
•
1x AAA battery spring contacts https://www.mb-sabers.com/shop
•
1x AAA battery contacts https://www.mb-sabers.com/shop
•
3x M2 washer
•
speaker cover ring https://www.mb-sabers.com/shop
•
speaker chamber accent LED spacer https://www.mb-sabers.com/shop
•
Emitter blade holder https://www.mb-sabers.com/shop
4