Plasma Gate accent 3mm/5mm LED
Prepare the
LED holder (example) for the PC-
tube
. Cut down the LED holder. Glue it into
the installed PC-tube.
(
This is just a suggested solution.
Actually
you can do what you like. It is also possible to
stick the LED into the tube... or more than one
LED in row... or one from each side. It´s up to
you. Also the LED holder can be something
different)
Plasma gate NeoPixel ring
The mb-sabers
NeoPixel ring
is specially designed to illuminate
the plasma tube with 6 Pixel. It is very small. 11.7mm diameter.
The
Pixel ring holder
is 3D printed.
Parts:
Pixel Ring shop:
Pixel Ring holder shop:
R1:
0603 resistor pad for data
(usually
330 Ohm
)
R2:
0603 resistor pad for + out
Din:
Data in (AWG 32)
Do:
Data out (AWG 32)
+ :
Vcc (AWG 26)
- :
GND (AWG 26)
+ out:
This pad is for additional
electronics like extra LEDs or a
motor which are placed inside
the plasma tube. The
+ wire
can
then be routed through the PCB
hole into the tube. This pad also has an own resistor pad
R2
!
IMPORTANT!: Don´t use it in series with the blade Pixel strip. The Pixel ring cannot handle much
current!
51
