Metallwarenfabrik Gemmingen Eisemann T 18000 E, Operating Instructions Manual

Page: 47 / 132

Introduction
3
 Read and note the information contained in this documentation. This will prevent
accidents, maintain the manufacturer’s warranty and provide for a good working
and operable power generator.
 The power generator is built exclusively for the purpose specified in the scope of
delivery (intended use).
Any other use than that intended is not applicable.
The manufacturer is not liable for any damages resulting from this.
The user alone bears the risk for this.
 Intended use includes the observance of the manufacturer-prescribed operating,
maintenance and repair conditions. The power generator may only be used, ser-
viced and repaired by persons familiar with and instructed on the dangers.
 Make sure that this documentation on operation, maintenance and repair is avail-
able to all interested parties and that the contents are understood.
 Failure to observe this documentation may result in malfunctions and damage as
well as personal injuries, for which the manufacturer does not assume liability.
 The requirement for proper maintenance and repair is the availability of all the
necessary equipment, hand and special tools, as well as their impeccable condition.
 Parts such as springs, clamps, elastic retaining rings, etc., when improperly han-
dled, increase the risk of injury.
 The relevant safety regulations as well as other generally recognized safety and
occupational health rules are to be observed.
 The highest efficiency, reliability and durability are only guaranteed with the use of
genuine parts.
 The repair of the power generator must correspond to the intended use. With ret-
rofitting, only parts freely given by the manufacturer for an intended purpose may
be used.
 Unauthorised modifications to the power generator void the liability of the manu-
facturer for any damages resulting from this.

With non-compliance, the warranty is void!