Metallwarenfabrik Gemmingen EISEMANN H 2801, User Manual

Page: 32 / 60

32
12. Possible causes of faults and their correction
No. Fault Cause of fault Fault correction
1 Motor cannot be started. Insufficient oil has been added, Check the oil level and if necessary
(Automatic oil level cut-out or the generator is standing on a slope top up; alternatively place on a level
switch operates) surface
2 The generator will not start There is motor oil in the combustion Remove the sparking plug and turn
chamber through excessive tilting of the motor over three or four times
the machine or it falling over. with the recoil starter. Clean carburet
tor and air filter.
Mechanical damage in the Repair or replace with new part(s)
area of the recoil starter or
the ventilator hood
3 The generator produces no, Capacitor defective Replace with new
or too little, voltage
Short circuit in the stator Replace with new stator
Motor revolutions too low. Bring to nominal rotational speed,
Excitation does not develop. no-load 3150 rpm, max. 250 volts