Metallwarenfabrik Gemmingen EISEMANN H 2801, User Manual

Page: 33 / 60

33
No. Fault Cause of fault Fault correction
Air filter and/or carburettor dirty Clean components and if necessary fit a
new filter cartridge
4 Voltage falls off under load Rotation speed of the motor Have the motor adjusted by an
either completely or very too low, or speed regulator authorised workshop to a nominal
substantially not functioning correctly speed of 3,150 rpm., max. 250 volts
Load too great Reduce the load
Generator's performance is Do not attempt to load the generator
affected by climatic influences with its nominal output - see instruction
handbook for the motor
5 Generator voltage too high Rotation speed of the motor too high Have the motor adjusted to its
nominal speed, but with a max. voltage
of 250 V.
6 Generator becomes Generator is being overloaded Switch off individual consumer units
unacceptably warm
Ambient temperature is excessive The generators are designed to operate
in ambient temperatures of up to +40°C
7 Generator stops, but can be Generator overheating cut-out
restarted after cooling down switch has been triggered See No. 6
In no circumstances are the adjusting screws marked in red to be re-adjusted. Such action will invalidate all and any claim under guarantee.
In case of any further fault, contact must be taken up either with the manufacturer or with an authorised maintenance workshop. When parts are
replaced, they must be replaced only by original spare parts.