and inserting wheel chocks. Never
disengage the parking brake while the
vehicle is raised.
R
the jack must be placed on a firm, flat and
non-slip surface. On a loose surface, a
large, load-bearing underlay must be used.
On a slippery surface, a non-slip underlay
must be used, e.g. rubber mats.
R
do not use wooden blocks or similar
objects as a jack underlay. Otherwise, the
jack will not be able to achieve its load-
bearing capacity due to the restricted
height.
R
The maximum clearance between the
underside of the tire and the ground must
be 1.2 in (3 cm).
R
never place your hands and feet under the
raised vehicle.
R
never lie under the raised vehicle.
R
never start the engine when the vehicle is
raised.
R
never open or close a door or the trunk lid
when the vehicle is raised.
R
make sure that no persons are present in
the vehicle when the vehicle is raised.
X
Using lug wrench
:
, loosen the bolts on
the wheel you wish to change by about one
full turn. Do not unscrew the bolts
completely.
The jacking points are located just behind the
wheel housings of the front wheels and just
in front of the wheel housings of the rear
wheels (arrows).
!
The jack is designed exclusively for
jacking up the vehicle at the jacking points.
Otherwise, your vehicle could be damaged.
X
Position jack
=
at jacking point
;
.
X
Make sure that the base of the jack is
positioned directly under the jacking point.
X
Turn crank
?
clockwise until jack
=
sits
completely on jacking point
;
and the
base of the jack lies evenly on the ground.
X
Turn handle
?
until the tire is 1.2 in
(3 cm) from the ground at most.
Flat tire
481
Breakdown
assistance
Z