X
Select
Cancel Route Guidance
and press
W
to confirm.
Continuing route guidance
X
To activate navigation mode: press the
S
function button once or twice.
X
To show the menu: press
W
the COMAND
controller.
X
Select
Destination
in the navigation
system menu bar by turning
cVd
the
COMAND controller and press
W
to
confirm.
X
Select
Continue Route Guidance
and
press
W
to confirm.
COMAND calculates the route.
Destination or area of destination
reached
When you reach your destination, COMAND
displays a checkered flag and route guidance
is automatically ended.
For certain points of interest (e.g. airports),
the
Destination Reached
display is shown
as well as the checkered flag.
Navigation announcements
Repeating navigation announcements
G
WARNING
Navigation announcements are intended to
direct you while driving without diverting your
attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Looking at the icons or map display can
distract you from traffic conditions and
driving, and increase the risk of an accident.
i
Audible navigation announcements are
muted during a telephone call.
If you have missed an announcement, you can
call up the current announcement at any
time.
X
To show the menu: press
W
the COMAND
controller.
X
In the navigation menu bar, confirm
RPT
with
W
.
Switching navigation announcements
on/off
X
To switch off: during the announcement,
press the
8
button on the multifunction
steering wheel.
You will briefly see the message:
The
driving instructions have been
muted
.
X
To switch on: press
W
the COMAND
controller.
X
In the
+
navigation menu bar, press
W
to confirm.
i
COMAND automatically switches the
navigation announcements back on when:
R
you have a new route calculated.
R
you start the engine again after having
left the vehicle.
Reducing volume during a navigation
announcement
The volume of an active audio or video source
can be automatically reduced during a
navigation announcement.
X
Select
Navi
in the main function bar by
sliding
ZV
and turning
cVd
the COMAND
controller and press
W
to confirm.
X
Select
Audio Fadeout
and press
W
to
confirm.
The function is switched on
O
or off
ª
,
depending on the previous status.
Setting the volume manually
X
Set the volume during a navigation
announcement.
or
X
In the map display when the menu is
shown, select
+
and adjust the volume.
174
Navigation
COMAND
