Selecting a point of interest using the
map
You can select points of interest that are
available in the selected (visible) section of
the map.
X
To activate navigation mode: press the
S
function button once or twice.
X
To show the menu: press
W
the COMAND
controller.
:
Highlighted point of interest
X
Slide
ZV
the COMAND controller forwards
and thereby activate the display window.
The map with highlighted point of
interest
:
is shown.
X
To highlight the next point of interest:
select
Next
in the menu bar by turning
cVd
and sliding
YVX
the COMAND
controller and press
W
to confirm.
X
To highlight the previous point of
interest: select
Previous
in the menu bar
by turning
cVd
and sliding
YVX
the
COMAND controller and press
W
to
confirm.
X
To display details of a point of interest:
select
Details
in the menu bar by turning
cVd
and sliding
YVX
the COMAND
controller and press
W
to confirm.
Route guidance
General notes
G
WARNING
COMAND calculates the route to the
destination without taking into account the
following, for example:
R
Traffic lights
R
Stop and right-of-way signs
R
Lane merging
R
Parking or stopping prohibited areas
R
Other road and traffic rules and regulations
R
Narrow bridges
COMAND may give incorrect navigation
commands if the data in the digital map does
not correspond with the actual road/ traffic
situation. For example, if the traffic routing
has been changed or the direction of a one-
way road has been reversed.
For this reason, you must always observe
applicable road and traffic rules and
regulations during your journey. Road and
traffic rules and regulations always have
priority over the navigation commands
generated by the system.
Route guidance begins once a route has been
calculated (
Y
page 160).
COMAND guides you to your destination by
means of navigation commands in the form
of audible navigation announcements and
route guidance displays.
The route guidance displays can only be seen
if the display is switched to navigation mode.
If you do not follow the navigation
announcements or if you leave the calculated
route, COMAND automatically calculates a
new route to the destination.
If the digital map contains the corresponding
information, the following applies:
R
when selecting a route, COMAND tries to
avoid roads that only have limited access,
170
Navigation
COMAND
