Mercedes-Benz Conecto, Manual

Page: 112 / 268

Driver's area controls
Operating displays/driving mode/bus stop mode
Operating displays/driving
mode/bus stop mode
To provide the driver with information in
an organised manner, the operating in-
formation is divided into three display
types: 1.) Operating displays, 2.) Dis-
plays in driving mode, 3.) Displays in
bus stop mode.
1.) Operating displays.
M54_00-1334-71
After the electrical system has been
switched on, each of the operating dis-
plays is displayed on the screen once in
succession. It is then only possible to
call up the operating displays by press-
ing pushbutton (1) on the instrument
panel.
Danger.
Risk of accident. Calling up additional
information while the vehicle is in motion
would divert your attention away from the
road and traffic conditions. This could
result in an accident with serious or fatal
injuries. For this reason, do not call up
information unless the bus is stationary
and the parking brake is applied.
Note:
This display mode remains active for ap-
proximately 5 seconds. Then, if the park-
ing brake is not applied or if the bus stop
brake or drive-off lock is not active, the
display mode switches to “Driving mode”.
If the parking brake is applied or if the
bus stop brake or drive-off lock is active,
the display mode switches to “Bus stop
mode”.
Splitscreen
The screen is split horizontally into two
differently sized areas. The upper area
occupies 3/4 of the screen, the lower
area 1/4. Both areas can be operated
independently using pushbutton (1).
Note:
The splitting of the screen is virtual, i.e.
there is no visible partition between the
two areas. The split is only evident when
the upper or lower area is operated inde-
pendently of the other using pushbutton
(1).
102
CONECTO (C628.3--)/08.2007 GB