525
Practical hints
Flat tire
1
Wheel wrench
왘
On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with wheel
wrench
1
).
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
2
Take-up bracket
3
Jack
4
Crank
왘
Place jack
3
on firm ground.
왘
Position jack
3
under the take-up
bracket
2
so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an in-
cline.
왘
Turn crank
4
clockwise until jack
3
is fully seated in take-up bracket
2
and the jack base evenly meets the
ground.
왘
Continue to turn crank
4
until the
wheel is a maximum of 1.2 in (3 cm)
from the ground.
!
Do not position the jack on the body of the
vehicle, as this may cause damage to the
vehicle.
!
Vehicles with factory-mounted
running-boards*:
Your vehicle is equipped with a scissors-type
jack (located under the cargo compartment
floor) designed for use with factory-mounted
running boards. Only use this jack when jacking
up vehicles with factory-mounted running boards
as otherwise the vehicle’s underbody can be
damaged. See separate instructions for
scissors-type jack.
컄컄
Summary of Contents for 2007 GL 320 CDI
