Mercedes-Benz 2007 GL 320 CDI, Operator'S Manual

Page: 183 / 595

182
Controls in detail
Control system
왘
Press button
j
or
k
repeatedly
until the message Compass setting
Zone
appears in the multifunction
display.
The selection marker is on the current
setting.
왘
Press button
æ
or
ç
to set the
respective compass zone.
For information on how to call up the
compass, see “Compass” (
컄
page 345).
Compass calibration
This function is not available if your vehicle
is equipped with the COMAND system and
navigation module*.
In order to calibrate the compass properly,
mind the following:
앫
Calibrate the compass in open terrain.
Nearby buildings, bridges, power lines
and large antenna masts, for example,
could impair compass calibration.
앫
Switch off electrical consumers (e.g.
climate control, windshield wipers, or
rear window defroster).
앫
Close all doors and the tailgate.
왘
Start the engine (
컄
page 57).
왘
Press button
æ
or
ç
to move
the selection marker to the Vehicle
submenu.
왘
Press button
j
or
k
repeatedly
until the message
Compass Calibration
appears in the
multifunction display.
The selection marker is on setting
switched off .
왘
Press button
æ
to set the selection
marker to Start .
The following message appears in the
multifunction display:
Compass Calibration active
Please drive in a full circle
i
Make sure you are in area where you can
drive a full circle with your vehicle without dis-
turbing traffic in order to calibrate the compass.
컄컄